Stellmotor Heckklappe durchmessen

[audiot]

Hi Tux,

Thanks - yes I'm afraid so.
One thing I would like to check, is to do the Block readings from the j256 without the B plug attached, to see if any other lines in the B plug are playing a role in the problem. (in my previous reading as mentioned above I only disconnected b13 and b14 from the plug). However, when I unplug the B plug, VAG COM looses connection to J256 - apparently because J256 looses power.

Do you know the pinout of the J256, so I can try and connect only the power lines, and simulate b13->GND and b14->GND - and that way omit the rest of the pins/cables?

Also - I presume its unlikely, but is there a way to test anything on the J256, disconnected?

Thanks!