09.03.2009, 23:22
Hi Micha,
First did you get my e-mail reply yesterday?
Yes I have two relays under the rear seat but I don't know the numbers of them in my head. I will check ASAP (which means after writning this post) I will also check for the big controller.
I went out and installed the gas struts in the roof lid. Now the lid stays up and don't fall down anymore. I hooked up VAG COM and did a diagnosis and the first thing I got that I never got before was
01108 Power closing relay
28-10 J292
Short to plus
which in the documentaion I refer to :
The only problem now is that I don't know where the J292 can be found.
I will contiune to view you the result of the check of the hood as I have some interesting results in VAG-COM, but that will be after the power windows have a solution.
First did you get my e-mail reply yesterday?
(09.03.2009, 21:16)Jenkins schrieb: Hello Lars!
There's one controller, as Tux wrote most commonly sitting on sockets 5+6. This controller can have printed on it 367 OR 363 OR 343 OR sth. else. But always only one controller. Bigger than the others.
But there's one point where I disagree with Tux: My cab from model year 1996 obviously doesn't have relay sockets 19 to 22. 'Cause I couldn't find them. But of course I don't know the details for model year 1994. Or 1993.
May be you should check whether there are relays under the rear seating or not.
Yes I have two relays under the rear seat but I don't know the numbers of them in my head. I will check ASAP (which means after writning this post) I will also check for the big controller.
I went out and installed the gas struts in the roof lid. Now the lid stays up and don't fall down anymore. I hooked up VAG COM and did a diagnosis and the first thing I got that I never got before was
01108 Power closing relay
28-10 J292
Short to plus
which in the documentaion I refer to :
The only problem now is that I don't know where the J292 can be found.
I will contiune to view you the result of the check of the hood as I have some interesting results in VAG-COM, but that will be after the power windows have a solution.